小v3 3M 60007000口罩

Faster print time
V3 is up, ENGLISH after Chinese description
中間夾層保鮮紙, 效果更佳
Slicer：
開口向下, 用support (Touching buildplate) , 唔洗brim, 唔好用raft
0.2 layer height
1.2 shell
0.8 top/bottom
20~30% fill (100% fill 有D機都係印唔到實心)
enable support (Touching buildplate)
no bed adhesion
flow rate 可以多1-5%
PLA 可以比平時印靚個溫度加10~20度
Printer：
確保extrude steps per mm 正確
for BEST PERFORMANCE, lay some plastic wrap fit, then screw in
place the mouth downwards and use support (Touching buildplate)
make sure your E steps/ flow rate is right.
Hard filament required (normal PLA is okay)
i'm doing
0.2 layer height
1.2 shell
0.8 top/bottom
20~30% fill
enable support (Touching buildplate)
no bed adhesion