迪威網(wǎng)友8d3e82
發(fā)布時(shí)間：2024/12/21 2:08:00
I've created this little glue able joycon joystick holder for my own electronic/arduino projects.
So this is to screw it up on nearly every surface just glue it to the surface at which you want to mount up the joystick.
I convert a joystick from the 90's (with gameport conection) to usb and try to build in a joycon joystick in the main joystick to be able to use it in the new microsoft flight simulator 2020. But I generaly like the small mesurments of the joycon joystick so I will maybe use it in other projects as well.
As you can see on the pictures I've also create a breakeout board for a fpc connector.
I'ts not the original connector (because it has 6 itead of 5 pi) but it should work if you push the joystick cable to the side.
To use this you also need:
two small screws
the eaching template for a fpc connector
(or a fpc break out board)
fpc connector 6 pin 0.5 mm
So this is to screw it up on nearly every surface just glue it to the surface at which you want to mount up the joystick.
I convert a joystick from the 90's (with gameport conection) to usb and try to build in a joycon joystick in the main joystick to be able to use it in the new microsoft flight simulator 2020. But I generaly like the small mesurments of the joycon joystick so I will maybe use it in other projects as well.
As you can see on the pictures I've also create a breakeout board for a fpc connector.
I'ts not the original connector (because it has 6 itead of 5 pi) but it should work if you push the joystick cable to the side.
To use this you also need:
two small screws
the eaching template for a fpc connector
(or a fpc break out board)
fpc connector 6 pin 0.5 mm
|
共個(gè)文件
壓縮包大?。?20KB
|
||
|---|---|---|
微信小程序
微信掃碼打開此模型
迪威模型
微信掃碼支付