迪威網(wǎng)友9e9883
發(fā)布時間：2024/2/23 8:02:00
PLATFORM FOR CRANE HO or OO
This little platform was built for the Wills / Peco yard crane. However, it could be used for any crane that fits on the 25mm turntable. I've added a printable crane - see notes below.
It is powered by a geared motor mounted below (see photo). The mountings for the motor are built into the plastic base and you just need 2 tiny screws (1.6mm I think). The turntable requires two M3 washe on the motor shaft to separate it from the base and act as a bearing.
The upper surface of the platform is deliberately uneven and will be coated with a dark grey or black scenic scatter, then matt varnished.
The sides are intended to look like regular building stone with a slate infill.
The motor has a 3mm shaft that pushes into the lower part if the 25mm turntable. The spigot on the base of the crane fits into a 2.5mm hole in the upper side of the turntable. If you want any info about the motor or it's mounting, please leave a comment.
I have built this for my own model railway layout. It prints okay without any brim or supports. Since printing, I have modified the undeide slightly. Any difficulties, please comment (politely) and I will modify.
UPDATE: I have now produced a 'wooden' crane platform and a yard crane. It's posted separately on Thingivee.
I hope this may be useful to someone.
This little platform was built for the Wills / Peco yard crane. However, it could be used for any crane that fits on the 25mm turntable. I've added a printable crane - see notes below.
It is powered by a geared motor mounted below (see photo). The mountings for the motor are built into the plastic base and you just need 2 tiny screws (1.6mm I think). The turntable requires two M3 washe on the motor shaft to separate it from the base and act as a bearing.
The upper surface of the platform is deliberately uneven and will be coated with a dark grey or black scenic scatter, then matt varnished.
The sides are intended to look like regular building stone with a slate infill.
The motor has a 3mm shaft that pushes into the lower part if the 25mm turntable. The spigot on the base of the crane fits into a 2.5mm hole in the upper side of the turntable. If you want any info about the motor or it's mounting, please leave a comment.
I have built this for my own model railway layout. It prints okay without any brim or supports. Since printing, I have modified the undeide slightly. Any difficulties, please comment (politely) and I will modify.
UPDATE: I have now produced a 'wooden' crane platform and a yard crane. It's posted separately on Thingivee.
I hope this may be useful to someone.
|
共個文件
壓縮包大小：3MB
|
||
|---|---|---|
微信小程序
微信掃碼打開此模型
迪威模型
微信掃碼支付