用于PRUSA i3 MK2的熱端聚四氟乙烯管修剪器。5SMK3SMK3S+

[English]
The PTFE tube ierted in the hotend of the PRUSA i3 MK2.5S/MK3S/MK3S must be bevel-cut at both ends at 60 degrees. It is recommended to purchase a genuine tube or drill it with a center drill, etc. However, to make it easier, I created jigs to cut and trim tube by using a standard craft knife (OLFA 10B/10BS) in Japan.
Iert the PTFE tube into the cutting jig for MK3S (42.3mm) or MK3S/MK2.5S (44.3mm) and cut.
Set the art knife into the inner trimmer, iert the PTFE tubing from the opposite side, and rotate it to trim. It is easier to hold the tube in place with the holder and rotate the knife side.
Trim the other side with the outer trimmer in the same way.
You can print it without any support.
[Japanese]
PRUSA i3 MK2.插入5S/MK3S/MK3S 的熱端的PTFE軟管兩端必須要切斷60度的錐。雖然推薦購買正品或使用中心鉆頭等進行加工，但是為了更簡單地制作，制作了使用一般的藝術刀（OLFA10B/10BS）進行切割和兩端修剪的夾具。
MK3S 用（42.3%）或MK3S/MK2。請將PTFE管插入5S用（44.3mm）的切口中，并切掉。
請將藝術刀設置到內耳修剪器的深處，從另一側插入PTFE管旋轉，削減尖端。用夾子固定軟管，使刀側旋轉更輕松。
同樣，請用外部修剪器將相反的一側也削掉。
可以不支持全部輸出。