pet bowl

The original plate is always overturned by it, or some cat food will be pushed to the side by it, and it is difficult to find it. If you keep adding it, it may break after a long time. Therefore, I designed this food plate and have been using it for a period of time. , the effect is very good, no cat food is spilled next to it, and it has not been turned over once.

On the front of the model, the inner edges are curved, and the food will not stay around, but will always be in the center.

The bottom is hollowed out to save material. No support is needed when printing. Just adjust the proportions and print directly. The design size is an overall diameter of 25cm. You can adjust the size according to your own cat, dog and printer.

Use black PLA to print, adjust the ratio to 80%, print out a diameter of 20cm, take 4.5 hours, use 130g of consumables, and cost about 7 yuan.

原來的盤子總是被它掀翻，或者有些貓糧會被它拱到邊上，吃不找，不斷添加，時間久了，可能會壞掉，所以，設計了這個食盤，目前使用一段時間，效果非常好，旁邊再?zèng)]有撒出貓糧，也沒有被翻過一次。

模型正面，內部邊緣是曲線，食物不會停留在四周，永遠在最中央。

下面鏤空，節約材料，打印時候無需支撐，調整好比例直接打印即可，設計尺寸是整體直徑25cm，根據自己的貓狗和打印機調整尺寸。

使用黑色PLA打印，比例調整為80%，打印出來直徑20cm大小，用時4.5小時，耗材130g，成本下來大約7元左右。