迪威網友7f58bb
發布時間：2020/4/15 3:31:00
V2 is up, ENGLISH after Chinese description
中間夾層保鮮紙, 效果更佳
Slicer：
開口向下, 用support, 唔洗brim, 唔好用raft
0.2 layer height
1.2 shell
0.8 top/bottom
20~30% fill
enable support
no bed adhesion
flow rate 可以多1-5%
PLA 可以比平時印靚個溫度加10~20度
Printer：
確保extrude steps per mm 正確
for BEST PERFORMANCE, lay some plastic wrap fit, then screw in
place the mouth downwards and use support
make sure your E steps/ flow rate is right.
Hard filament required (normal PLA is okay)
i'm doing
0.2 layer height
1.2 shell
0.8 top/bottom
20~30% fill
enable support
no bed adhesion
中間夾層保鮮紙, 效果更佳
Slicer：
開口向下, 用support, 唔洗brim, 唔好用raft
0.2 layer height
1.2 shell
0.8 top/bottom
20~30% fill
enable support
no bed adhesion
flow rate 可以多1-5%
PLA 可以比平時印靚個溫度加10~20度
Printer：
確保extrude steps per mm 正確
for BEST PERFORMANCE, lay some plastic wrap fit, then screw in
place the mouth downwards and use support
make sure your E steps/ flow rate is right.
Hard filament required (normal PLA is okay)
i'm doing
0.2 layer height
1.2 shell
0.8 top/bottom
20~30% fill
enable support
no bed adhesion
|
共個文件
壓縮包大?。?MB
|
||
|---|---|---|
微信小程序
微信掃碼打開此模型
迪威模型
微信掃碼支付