發(fā)布時間：2019/3/28 20:37:00
This is veion 5 of the CHAMP. It is a snap-on type for easy itallation, removal, and use. It has a movable friction latch for an extra secure fit. It is printed in one go or separately if desired. Pull tab to release/adjust.
Extrusion direction is along the long z axis of part.
This is a link to veion 1 >> NASA Handrail Clamp - V1 (updated)
This is a link to veion 2 >> NASA Handrail Clamp - V2 (updated)
This is a link to veion 3 >> NASA Handrail Clamp - V3 (updated)
This is a link to veion 4 >> NASA Handrail Clamp - V4 (updated)
This is a link to veion 6 >> NASA Handrail Clamp - V6 (updated)
**************************************************************************************
rev1
1. Optimized geometry
**************************************************************************************
rev2
1. Revised geometry
Extrusion direction is along the long z axis of part.
This is a link to veion 1 >> NASA Handrail Clamp - V1 (updated)
This is a link to veion 2 >> NASA Handrail Clamp - V2 (updated)
This is a link to veion 3 >> NASA Handrail Clamp - V3 (updated)
This is a link to veion 4 >> NASA Handrail Clamp - V4 (updated)
This is a link to veion 6 >> NASA Handrail Clamp - V6 (updated)
**************************************************************************************
rev1
1. Optimized geometry
**************************************************************************************
rev2
1. Revised geometry
|
共個文件
壓縮包大?。?2MB
|
||
|---|---|---|
微信小程序
微信掃碼打開此模型
迪威模型
微信掃碼支付